Model 670C Berkeley Nucleonics Corp. 27 of 96
If you are a beginner user, you can follow the steps here below to generate your first waveform.
1. Connect the power cord and the push the front-panel on/off switch to turn on the
instrument.
2. Press the AWG/AFG button to switch from the Simple AFG to the Simple TrueArb
application. Wait until the Simple TrueArb application is executed and ready to accept new
commands.
3. Connect the Output 1 of the instrument to the oscilloscope input with a cable, select 50 Ohm
load on the oscilloscope input.
4. Touch the settings button
on the Simple TrueArb UI to open the instrument settings
window
5. Select Dev. Settings ➔ General page, select Continuous as Run Mode
To Next Page
Loading...