OPERATOR CAB (SIN
20001
& Above)
Removal And
Installation
Remove the stop blocks at the rear
of
the operator cab
[A).
IMPORTANT
After the
stop
blocks
are removed
and
the
operator cab
has
a rear window, REMOVE THE
REAR
WINDOW
to
prevent damage
to
the
rear
window.
1-212(H)297
Raise the operator cab. (See PREVENTIVE
MAINTENANCE
Section 1 for the correct procedure.)
Disconnect the
electrical harness [B).
Remove the
electrical harness clamp [C).
Install a bar through the operator cab balance point.
Install a chain and chain hoist [0).
-5-3-
741,742
, 743,
74305
Bobcat
Loader
Service Manual
To Next Page