Bobcat 741 - Page 26

OPERATOR CAB (Cont'd)
Raising The Operator Cab
The cab can be raised or lowered with the lift arms up or
down.
If the lift arms are up, a lift arm support device must be
installed. (See Page 1-4 .)
A WARNING
Before the cab or the lift arms are raised for
service, jackstands must be put under the rear
corners
of the frame. Failure to use jackstands
can
allow the machine to tip backward causing
injury or death.
W-2014-0895
A WARNING
AVOID INJURY
Cylinders for raising and lowering operator cab
have gas under pressure. Do not open cylinder.
Only qualified
service personnel can remove
the
cylinder.
W-2112-{)987
Stop the loader on a level surface. Stop the engine and
engage the brake.
Put jackstands under the rear of the
loader.
Disconnect the two front fasteners.
If the lift arms are down, stand on the safety tread [A).
If the lift arms are up, stand beside the loader [B).
Slowly raise the cab until it is all the way up [A] or [B] .
Lowering The Operator Cab
Stand on the safety tread [A] or beside the loader [B] and
slowly lower the operator cab.
A WARNING
Both sets of fasteners at the front of the
operator cab (ROPS) must be assembled as
shown in
this manual. Failure to secure ROPS
correctly
can cause injury or death.
W-2005-1189
Install the fasteners before operating the loader.
A
B
-1-6-
B-07463
741,742,743, 7430S Bobcat Loader
Service
Manual