ENGINE (Cont'd)
Removal And Installation
(Cont'd)
Drain the coolant into a container
[Aj.
Installation:
Make sure to
pre-mix
the water (50%) and
ethylene glycol (50%) before adding it to the cooling
system.
Remove the radiator hose from the thermostat housing
[B).
Disconnect the air
cleaner hose [C).
Turn the
fuel shutoff to the OFF position on the fuel tank.
Disconnect the
fuel line from the fuel pump
[0).
Added Sept.
90
-70-17-
A
741,742, 743, 7430S Bobcat Loader
Service Manual
To Next Page