Bobcat s250 - Hydraulic Controls (Continued); Rear and Secondary Front Auxiliary Hydraulics

S250 Bobcat Loader
OI-21 Operation & Maintenance Manual
HYDRAULIC CONTROLS (CONT’D)
REAR Auxiliary Hydraulics Operation
Figure OI-34
The switches on the left hand lever control the rear
auxiliary hydraulics.
Press the auxiliary hydraulics button for MAXIMUM
FLOW (See Auxiliary Hydraulics Button - MAXIMUM
FLOW ONLY on Page OI-20).
Push the switch (Item 3) [Figure OI-33] to the right or left
to change the fluid flow direction to rear quick couplers
[Figure OI-34]. (EXAMPLE: Raise and lower rear
stabilizers.)
WARNING
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks.
Do not use your bare hand. Wear safety goggles.
If fluid enters skin or eyes, get immediate medical
attention from a physician familiar with this injury.
W-2007-0497
Secondary Front Auxiliary Hydraulics (If Equipped)
Figure OI-35
The secondary front auxiliary quick couplers (Item 1)
[Figure OI-35] are available a Field Installed Accessory.
These are used when there is a need for additional
auxiliary hydraulics (EXAMPLE: Planer side shift).
Connect the attachment to the secondary auxiliary
hydraulics (Item 1) [Figure OI-35].
Set the Auxiliary Hydraulic Button for Variable Flow or
Maximum Flow Only. (See Auxiliary Hydraulics Button -
VARIABLE FLOW on Page OI-20). or (See Auxiliary
Hydraulics Button - MAXIMUM FLOW ONLY on
Page OI-20).
Figure OI-36
Push switch (Item 1) [Figure OI-36] to the right or left to
change fluid flow direction. (EXAMPLE: Side shift on the
Planer.)
NOTE: The secondary front auxiliary hydraulics and
the rear auxiliary hydraulics operate from the
same auxiliary section of the control valve. To
operate only one of these auxiliary functions,
disconnect the other.
P-31243
P16291
1
SECONDARY
COUPLERS
P-31833
1
Right Steering Lever
P-16537
Left Steering Lever