108 S650 Operation & Maintenance Manual
ATTACHMENTS (CONT’D)
Installing And Removing The Attachment (Power
Bob-Tach) (Cont’d)
Removing
Lower the lift arms and put the attachment flat on the
ground. Lower or close any hydraulic equipment, if
applicable.
If the attachment has electrical, water or hydraulic
connections to the loader:
1. Stop the engine and exit the loader. (See STOPPING
THE ENGINE AND LEAVING THE LOADER on Page
100.)
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s seat:
• Lower the lift arms and put the attachment flat on
the ground.
• Stop the engine.
• Engage the parking brake.
• Raise the seat bar.
• Move all controls to the NEUTRAL / LOCKED
position to make sure the lift, tilt and traction
drive functions are deactivated.
The seat bar system must deactivate these functions
when the seat bar is up. See your Bobcat dealer for
service if controls do not deactivate.
W-2463-1110
2. Disconnect attachment electrical harness and water
or hydraulic lines, if applicable, from the loader. (See
Relieve Auxiliary Hydraulic Pressure (Loader And
Attachment) on Page 84.)
3. Enter the loader and perform the PRE-STARTING
PROCEDURE. (See PRE-STARTING PROCEDURE
on Page 88.)
4. Start the engine, press the PRESS TO OPERATE
LOADER button and release the parking brake.
Figure 143
Figure 144
Push and hold
BOB-TACH “WEDGES UP” switch (Right
Switch Panel) [Figure 143] until levers (Item 1)
[Figure 144] are fully raised (wedges fully raised).
P-85320C
P-85361A
1
To Next Page
Loading...