Body Clock Stimplus - Electrode Placement and Maintenance; Troubleshooting and Device Support; Checking System Performance

Electrode Placement (Gold tip)
For reducing the pain, place the gold tip
on or above the point of pain.
Maintenance and Care
Guidelines for optimum performance:
• Change the battery regularly.
• The unit must be switched off when
changing the battery.
• The unit should be wiped clean
periodically using a very slightly
dampened cloth. A mild soap may
be used but DO NOT apply solvents.
General Precautions:
• Do not immerse your Body Clock
Stimplus or Stimplus Pro in water or
any other liquid
• Do not place the device close to any
source of excess heat
• Do not operate the device in the
presence of flammable gases
• Do not attempt to open the Body
Clock Stimplus or Stimplus Pro unit
• Do not use battery or power sources
other than those specified
• Do not drop this unit onto a hard
surface
Checking system performance and
trouble shooting
• If the “red” LED lamp illuminates
when the power switch is turned on,
turn the device off. Then replace the
two three (3) volt batteries and turn
the device on again. If it still does
not function, return the device for
repair.
15