The radio shielding of the device has
been ascertained according to VFG
243/1991 (interference suppression of
ISM devices).
Shapes of output curves under a 500 ohm load
How to Use the
Body Clock Stimplus Pro
1. Activate the Body Clock Stimplus Pro
by turning the power switch on.
2. PLEASE NOTE that the device must
be held by the person being treated,
as the passive contact plate acts as
one end of a circuit, the other being
the tip of the device, which is
applied to the desired point. When
treating another party, the operator
should hold the device onto the
points to be treated, and ensure that
physical contact is maintained
between the operator and the other
party in order to complete a circuit.
(See right). Alternatively, the wrist
strap included with this unit may be
used to the same effect. The wrist
strap consists of a lead with the
wrist strap at one end and a jack
plug at the other end. If the strap is
8
To Next Page
Loading...
