9
used, the jack plug should be
inserted into the jack on the
underside of the device. The wrist
strap should then be worn by the
other party. There is then no need
for physical contact to be
maintained between the operator
and the other party. Stimulation
may then be commenced.
3. Begin stimulation by selecting the
desired stimulation time by setting
the time selector switch. A preset
time of 15 or 30 seconds may be
selected or alternatively manual
stimulation, which lasts as long as
you choose.
4. If a preset stimulation time is
chosen, just press the stimulation
button briefly and release. The
device will automatically stop
stimulating when the preset time is
over. If manual stimulation is
selected, the device will stimulate
for as long as you press the
stimulation button.
5. When the unit is switched off, the
intensity level will automatically be
reset to minimum. You can see the
previous intensity setting by
pressing the intensity button, after
which, the previous intensity will
appear for 5 seconds in the 6 LED
bar scale. You can then increase or
decrease that preset intensity level
before beginning stimulation.
6. You may select one of three
frequencies during stimulation: 5Hz,
10Hz or 20Hz. You can select the
To Next Page
Loading...
