BUB350/BUB375 Page 5
Assembly STEP 1
Attach Upright Frame (#01) to the Main Frame (#02), secure
them together by using two Hex Bolt (#11), two Washers
(#18) and two Nylon Nuts (#16).
Hardware Required
NOTE:
To avoid misalignment due to over-tightening,
please do not use a wrench at this time.
Hand-tightening for now will help ensure easy
assembly.
Wrench-tightening should be performed after all
parts are assembled to ensure all nuts, bolts, and
parts are tightly secured before use.
#16
Nylon Nut (M8)
[2 Pieces]
#11
Carriage Bolt (M8x75 mm)
[2 Pieces]
#18
Washer (Ø8.3xØ16)
[2 Pieces]
To Next Page
Loading...
