Body Solid GDR34 - Step 2: Attaching Remaining Trays

10
STEP
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 2A. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
2A. AttachDumbbellTrays(B)toUprights(A)using:
8 - (#1) M10x65mm Socket Head Cap screw
8 - (#2) M10 Nylon Lock Nut
4 - (C) Steel Bracket