Hot water function
9 10
Milk frothing function
Milk frothing Method:
1. Press the “ ” button and then press the “ ” button, the indicator
of “ ” on the screen will flash until the steam preheating is completed.
2. Pour cold whole milk into the jug (1/3 full) and put the steam nozzle into
the milk (1cm deep), then turn the “steam knob” slowly in anti-clockwise
motion until steam starts to spray out.
Attention:
The amount of steam is adjustable
according to personal proficiency. Always
remember to release a little water from
the steam pipe before milk frothing.
3. When the volume of milk has approximately doubled, turn off the “steam
knob” and the “steam button” at the same time (clockwise direction is off).
After milk frothing, use a wet towel to clean
the milk on the surface of the steam nozzle
in time and spray steam again by turning
on the steam function to avoid dry milk
from blocking the air outlet.
4. You can now pour the milk into the coffee cup.
Note:
1．You can sprinkle with cocoa powder/chocolate sauce as desired and
make a cup of Mocha coffee.
2．If the coffee indicator light flashes quickly, this means that the
temperature is too high. You can use the hot water function to cool down.
HOT WATER FUNCTION
1. Press the “ ” button. The machine will start to warm up and
corresponding light of the coffee button flashes (as shown here by the
arrow).
After preheating, the coffee indicator light
remains light up. You may then press the
“coffee button” and anticlockwise rotate the
steam knob, then hot water comes out
through the steam tube and you can use
hot water to drink, wash or heat the cup.
When you have finished doing the steps above, press the “coffee button”
again. The machine will stop working and you can clockwise rotate the
steam tube to OFF at the same time.
2. Finally press “ ” button to turn off the machine.
To Next Page
Loading...