What to do if there is water on table from BOJ Coffee Maker?
If you notice water on the table around your BOJ Coffee Maker, several factors could be the cause: * The water tank might be leaking due to a stuck valve. Check the valve on the water tank. * The drip tray could be full and overflowing. Empty the drip tray. * The brewing chamber might have been opened without the drip tray in place. Ensure the drip tray is correctly positioned.
Why is the coffee from my BOJ CCM-800 not hot enough?
If the coffee from your BOJ Coffee Maker isn't hot enough, there could be a few reasons: 1. Cold cups/mugs can lower the coffee temperature. Preheat your cup or mug before brewing. 2. Scale build-up in the machine can affect heating. Descale your machine. 3. For a cold machine, try brewing a cup of water first to warm up the circuit.
What to do if capsule can’t drop down in BOJ CCM-800 Coffee Maker?
If the capsule is not dropping down in your BOJ Coffee Maker, it could be due to: * The used capsule container being full. Empty the used capsule container. * The capsule being deformed after brewing. Try pushing it down with your finger, or close the handle and open it again.
Why is there steam when handle opened on BOJ CCM-800 Coffee Maker?
If you notice steam escaping when you open the handle of your BOJ Coffee Maker, it's likely because you opened the handle too quickly after brewing. Allow a few seconds for the residual pressure to escape before opening the handle.
Why does coffee come out in drips from my BOJ Coffee Maker?
If coffee comes out in drips or goes directly into the used capsule container when using your BOJ Coffee Maker, it's likely that the ground coffee in the capsule is too fine to allow water to pass through properly. Try using a new capsule.
Why does capsule drop directly to used capsule container in BOJ CCM-800?
If the capsule drops directly into the used capsule container in your BOJ Coffee Maker, it may be due to the capsule being deformed. Try inserting the capsule again at a slightly different angle or use a new capsule.
Why are there occasional drops dripping out of the dispensing head of BOJ CCM-800?
Occasional drops dripping from the dispensing head of your BOJ Coffee Maker are normal. This happens because the heater is keeping warm, and it is not a defect.
Essential safety instructions to follow before operating the coffee machine.
Precautions regarding electric shock, grounding, and cable handling.
Warnings about burns, scalding, and hot parts during operation.
Steps for unpacking and verifying all included components.
Instructions for the initial setup and first operation of the machine.
Guidance on using compatible coffee capsules with the machine.
Identification of key components like handle, buttons, dispenser, and tanks.
Explanation of the status and functions of various indicator lights.
Procedures for filling the water tank with or without removing it.
Steps to flush the machine and internal piping before first use.
How to adjust brewing temperature and program coffee volume.
Step-by-step guide to brewing espresso and lungo coffee.
How to use energy saving mode and perform routine cleaning.
Instructions to restore the machine to its default factory settings.
Procedure to remove water for storage or transport to prevent frost damage.
Detailed guide on how to decalcify the coffee machine to remove limescale.
Guide to diagnose and resolve frequent issues with the coffee machine.
Key technical specifications and information on product recycling.
General| Brand | BOJ |
|---|---|
| Model | CCM-800 |
| Category | Coffee Maker |
| Language | English |
To Next Page