Troubleshooting
|
19
Troubleshooting
Problem Solution
The VM-110 is stuck in the
camera hot shoe.
•Make sure that the mounting foot lock is released. (Page 14)
The VM-110 is turned on and is
in Light mode but won’t light up.
•Make sure that fresh batteries are installed and are in the proper
orientation. (Page 10)
The VM-110 is turned on and is
in Flash mode but won’t re.
•Make sure that fresh batteries are installed and are in the proper
orientation. (Page 10)
•Make sure the control unit is securely attached to the camera. (Page
12)
•Make sure that the electrical contact on the foot of the control unit is
not dirty. Clean it and try again.
The VM-110 is rotating right
or left while the camera is
focusing.
•Your lens has a rotating front element. Use manual focus.
To Next Page
Loading...