Boltek EFM-100 - Configuring the Software; EFM Options: General; Figure 17: EFM Options - General

C H A P T E R 3 – C O N F I G U R I N G T H E S O F T W A R E
17
Configuring the Software
EFM Options: General
Figure 17: EFM Options – General
Number of Data Sources
Enter the number of field mills for which you would like to display data. The minimum number is 1
field mill. The maximum number is four field mills. If you have more than four field mills you will
require a second computer for each additional four field mills creating a multi-monitor display.
Chapter
3