Bolva 32BF20 - TV Provider Setup & Channel Auto Scan

To Next Page

To Previous Page

TV Settings

TV Provider Setup

& Channel Auto Scan

To enter the Channel Menu:

• Press the MENU button

•

Using the   arrow buttons; scroll to highlight Channel

• Press the down  arrow buttons to highlight Air / Cable

Select Cable if you subscribe to a pay television service WITHOUT a set top box.

• Press the   arrow buttons to highlight Cable.

•

NOTE: Channel Auto Scan may take several minutes to complete.

Cable Mode

Air Mode

Select Air when TV is connected to an indoor / outdoor antenna.

• Press the   arrow button to highlight Air.

•

NOTE: Channel Auto Scan may take several minutes to complete.

NOTE: For Cable or Satellite users WITH a set-top box, there is no need to run Channel Auto

Scan. Connect your cable or satellite set top box to one of the available inputs on the TV for

viewing.

Press the  arrow button to highlight Auto Scan and press ENTER. Press ENTER to begin Auto Scan.

After the Setup Wizard has been completed, please skip this page as your Cable/Antenna

is already set up. The following instructions on this page are provided if you need to make

changes at a later time.