Advanced Settings
P-SETTINGS
P-Settings are used to control your Bolzzen Commando’s Advanced Settings. To enter the P-Settings screen, Long-Press the “M”
button. Follow the button layout in the previous page to navigate.
GET GOING – QUICKLY!
P-Setting Use Recommended Value
P0 Speed Unit (KMPH/MPH) KM/H
P1 Password Entry Screen 1159
P2 Password Function (For Power On) On
P3 Change Password Function
Please Remember The New Password.
If You Forget Your New Password, Long-press “M” And “-” Buttons For 2-seconds To Reset Password To Factory
P4 Wheel Diameter Setting 10
P5 Battery Voltage Setting 48
P6 Not Used
P7 Not Used
P8 Zero Start Off
P9
Cruise Control
(After Turning On, Holding The Accelerator At A Steady Level For 2 Seconds And Cruise Will Be Set. To Cancel Cruise, Switch Down A Gear, Or Long-press “M”)
P10 Speed Limit Options are On of Off for the 25km/hr Speed Limit
Master Code is: 1111
After entering, short press mode
to continue.
To Next Page
Loading...
