Bomag BW 174 AP-4 - User Manual

Service Training BW 154/174-4 AP
Status: 25. November 2010 Page 1 of 38
Author: H.Mueller/VK
ELECTRICS–
TRAINING
BW 154 AP-
4
BW 174 AP- 4
- Version 1.01 -
P/N 008 097 67

Summary

Displayed Monitoring Activities with Fault Reactions

How to Proceed When Replacing Components

How to Proceed When Replacing an ESX Control (A34)

Steps for replacing the ESX control unit.

How to Proceed When Replacing a Data Collector Module (A80)

How to Proceed When Replacing a Travel Pump

How to Proceed When Replacing a Steering Valve

How to Proceed When Replacing a Steering Angle Transducer

How to Proceed When Replacing a EGAS Actuator

How to Proceed When Replacing a Slope Sensor

Functions of the ESX Control

Setting the Machine Type

Procedure for setting the correct machine type in the ESX control.

Adjusting the EGAS Actuator

Steps for adjusting the EGAS actuator for correct engine operation.

Adjusting the Slope Sensor

Calibration of Angle Transducers

Steps for calibrating front and rear drum angle transducers.

Adjusting the Angle Transducers

Procedure for adjusting angle transducer positions for correct steering detection.

Automatic Detection of Surge Currents on Steering Valves

Process for automatically detecting surge currents in steering valves.

Automatic Detection of Surge Currents in Travel System

Process for automatically determining surge currents in the travel system.

Fault Log - Display and Delete

Procedure to display and delete fault codes in the ESX control.

Adjusting the Chip Spreader Type

Activating Edge Cutting Units

Description of Fault Codes on the ESX Control

Bomag BW 174 AP-4 Specifications

General

Brand	Bomag
Model	BW 174 AP-4
Category	Construction Equipment
Language	English