Need help?Do you have a question about the Bomag BW 154 AP-4 and is the answer not in the manual?
Details of document versions, dates, and descriptions of changes.
Records of software versions, release dates, and associated changes.
System monitoring displays, fault codes, and corresponding reaction types.
List of common faults, their causes, and recommended troubleshooting steps.
Step-by-step guide for replacing the ESX control unit.
Procedures for replacing data collectors, pumps, valves, sensors, and actuators.
Identifies components that do not require a post-replacement adjustment procedure.
How to navigate the ESX display and enter service codes for functions.
Procedure for testing brake efficiency using the ESX control system.
Setting the correct machine type in the ESX control for proper operation.
Calibration and adjustment procedures for EGAS actuator and slope sensor.
Detailed steps for calibrating front and rear angle transducers.
Automatic detection of surge currents for steering and travel systems.
How to display and delete stored fault codes in the ESX control.
Configuration steps for the chip spreader and edge cutting units.
Terminal descriptions and nominal values for ESX control signals.
Signal specifications for data collector and travel lever modules.
Signal specifications for display modules and the BLM IO module.
Categorized list of fault codes, their descriptions, and potential causes.
Explanation of different fault reaction levels and their implications for machine operation.
Special note codes indicating operating states, not requiring immediate service.
General| Engine Power | 55 kW |
|---|---|
| Vibration Frequency | 50 Hz |
| Drum Width | 1, 400 mm |
| Steering Mode | Articulated |
| Engine Manufacturer | Deutz |
| Centrifugal Force | 70 kN |
| Drum Diameter | 1200 mm |
To Next Page