BOMANN DU 623.2 - Cleaning and Maintenance

3 Power level:
Power level:Power level:
Power level:
The motor runs at high speed. The setting is suitable if large quantities of smoke and steam need to be e
tracted or filtered (e.g. when frying).
NOTE
NOTENOTE
NOTE:
::
:
If a lot of vapour
is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
running if absolutely necessary, since otherwise unnecessary energy is consumed.
The appliance and the operation
there
well as the filter. The ex
tractor hood and
WARNING:
WARNING:WARNING:
WARNING:
•
Before cleaning or maintenance work, the device should always turn off and
switch off the fuse.
• Allow the unit to cool down be
fore
• Do not uses steam cleaners for
electric shock!
electric shock!electric shock!
electric shock!
Hot steam could dam
tion.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
•
Do not use a wire brush or other sharp, abrasive items.
•
Do not use any acidic or abrasive
• To clean the surface of the
housing, use a mild
•
The appliance can be used again after
• If you use your ex
tractor hood in recirculation mode, you must
(see “Replacing the activated car
bon
Cleaning the alumin
Cleaning the aluminCleaning the alumin
Cleaning the aluminum
um um
um grease filter
grease filtergrease filter
grease filter
WARNING: Risk of fire!
WARNING: Risk of fire!WARNING: Risk of fire!
WARNING: Risk of fire!
Grease residues in the alumin
peratures. It is therefore important that the grease filter is regularly cleaned / r
placed.
Grease and vapours collect in the
filter
clean the grease filter monthly:
• Remove the aluminum grease
filter
tly and pull out towards the front.
• Rinse the grease filter in a
solution
tion.
• Then clean with a soft brush,
rinse
23
The motor runs at high speed. The setting is suitable if large quantities of smoke and steam need to be e
is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
running if absolutely necessary, since otherwise unnecessary energy is consumed.
Cleaning and Maintenance
Cleaning and MaintenanceCleaning and Maintenance
Cleaning and Maintenance
there
of are best maintained by regular clean
ing of your
tractor hood and
accessories should also be cleaned regularly for hygiene reasons.
Before cleaning or maintenance work, the device should always turn off and
dis
connect
fore
cleaning.
cleaning the device; moisture could enter
electrical
Hot steam could dam
age the plastic parts.
The device must be dry before restarting oper
Do not use a wire brush or other sharp, abrasive items.
Do not use any acidic or abrasive
cleaners.
housing, use a mild
detergent and a soft cloth to pre
vent scrat
The appliance can be used again after
everything has dried properly.
tractor hood in recirculation mode, you must
replace the acti
vated
bon
filter”).
Grease residues in the alumin
um grease filter may ignite on exposure to high te
peratures. It is therefore important that the grease filter is regularly cleaned / r
filter
and may accumulate if not regularly
cleaned. We
filter
by sliding back the lock in the handle re
cess,
solution
of hot water and neutral detergent. Soak
the
rinse
thoroughly with hot water and leave to dry.
The motor runs at high speed. The setting is suitable if large quantities of smoke and steam need to be e
x-
is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
ing of your
extractor hood as
accessories should also be cleaned regularly for hygiene reasons.
connect
the mains plug or
electrical
components. Risk of
Risk of Risk of
Risk of
The device must be dry before restarting oper
a-
vent scrat
ching.
vated
carbon filter regularly
um grease filter may ignite on exposure to high te
m-
peratures. It is therefore important that the grease filter is regularly cleaned / r
e-
cleaned. We
recommend that you
cess,
push the filter down gen-
the
grease filter in the solu-