EasyManua.ls Logo

BOMANN EBK 962 - Technical Data; Disposal

BOMANN EBK 962
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Problem Possible cause / What to do?
Display code:
E1
Fault display /
power supply
board
Disconnect the
power supply
for a short time,
if necessary ⇨
Call a specialist
Display code:
E2
Relay failure
NOTE:
If a problem still persists after following the steps
above, contact your distributor or an authorized tech-
nician.
Technical Data
Electrical connection...…………………………………..
Connection voltage: ….220-240/380-420V 2N~ 50/60Hz
Connection power: ………………………………..6000 W
Fuse protection: ……………………..….……......2 x 16 A
Dimension H x W x D / Weight…..…...………………..
Hob: …………………………..…...…5.5 x 58.0 x 51.0 cm
Cutout: .....................................................56.0 x 49.0 cm
Net weight: ……….……………………...…approx. 8.2 kg
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations
Disposal
Meaning of the “Dustbin” Symbol
Protect our environment; do not dispose of electrical
equipment in the domestic waste.
Please return any electrical equipment that you will
no longer use to the collection points provided for
their disposal.
This helps avoid the potential effects of incorrect
disposal on the environment and human health.
This will contribute to the recycling and other forms of
reutilization of electrical and electronic equipment.
Information concerning where these can be disposed
of can be obtained from your local authority.
WARNING:
Remove or disable any existing snap and bolt locks,
if you take the unit out of operation or dispose it.
Information to professional users for disassembly
(acc. VO (EU) No. 66/2014 appendix I, No. 2)
Information for non-destructive disassembly for
maintenance purposes
A further disassembly for maintenance purposes
by the user is not provided. Do not disassemble
the unit.
For repair and replacement of defective parts,
please contact our customer service.
Accumulators are not included.
Information for disassembly in terms of recycling,
recovery and disposal at the end of the life of the
appliance
The disassembly of appliances with a gas con-
nection should only be carried out by a licensed
gas and water installer.

Related product manuals