10
programs, except in the time controlled program
[60 MIN].
Capacity
CapacityCapacity
Capacity
Do not overload the appliance, otherwise the fabrics
will become stretched and drying will be impaired.
Refer to the information in the "Program table".
Starting
Starting Starting
Starting the
thethe
the
program
programprogram
program
• Connect the appliance to the power supply.
• Put the washing into the drum.
• Switch the appliance on.
• Select the required operating conditions.
• Start the drying operation.
Program change
Program changeProgram change
Program change
A change is not possible after a successful startup.
To select a new program, you must switch the appli-
ance off and on again.
End of program
End of programEnd of program
End of program
At the end of the drying cycle will sound a series of
signals; the control panel goes into standby mode
and the appliance starts an automatic anti-crease
cycle.
Automatic anti
Automatic antiAutomatic anti
Automatic anti-
--
-crease cycle
crease cyclecrease cycle
crease cycle
If you do not remove the clothes from the appliance
after the drying process has finished, the appliance
will start the automatic anti-crease cycle of approx.
30 minutes (the anti-crease control lamp is flashing).
The appliance continues rotating the drum in inter-
vals in order to prevent textiles from creasing. At the
end of that cycle the appliance will stop operating
completely. During the process you can remove the
washing at any time.
Switch off
Switch offSwitch off
Switch off
• Switch the appliance off.
• Clean the lint filter as described under “Cleaning
and Maintenance”.
• Leave the appliance door slightly open until the
next dry cycle to avoid odors.
• If the appliance is not in use for an extended time:
-
disconnect it from the power supply!
Energy saving tips
Energy saving tipsEnergy saving tips
Energy saving tips
• Take advantage of the maximum capacity of each
dry program.
• Select the dry program depending on the type of
laundry and the required degree of dryness.
• Dry the laundry not excessively. This protects
your laundry, prevents wrinkling and save energy.
• Clean the filter regularly to avoid excessive drying
and high energy consumption.
• Ventilate the room well. The room temperature
should not rise above 35°C.
Cleaning and
Cleaning and Cleaning and
Cleaning and Maintenance
MaintenanceMaintenance
Maintenance
WAR
WARWAR
WARNING
NINGNING
NING:
::
:
• Always switch off the appliance and disconnect it
from the power supply before cleaning and user
maintenance.
• Allow the appliance to cool down sufficient before
cleaning.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock!
Risk of electric shock!Risk of electric shock!
Risk of electric shock! Hot steam could damage
the plastic parts. The appliance must be dry be-
fore restarting operation.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
Maintenance of the
Maintenance of the Maintenance of the
Maintenance of the appliance
applianceappliance
appliance
• Clean the appliance outer surfaces and the door
sealing thoroughly with a soft, damp cloth. Use
only mild cleaning agent.
To Next Page
Loading...
