BOMANN WTK 7181 - Installation

6
Installation
WARNING:
The unit must not be connected to the mains during
installing. Otherwise there is
danger to life
or
electric
shock hazard
!
Installation location
 The site should be located near a properly
grounded power socket. The socket must be
freely accessible.
 Good ventilation around the appliance is required,
in order to dissipate the heat properly. Enough
clearance must be created for this purpose.
 The free space in front of the unit should be so
that the appliance door can be opened without
hindrance.
 Make sure that the floor on which the appliance is
installed, is even, heat-resistant and clean.
 Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly (see “Adjust the
feet”).

Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors),
as metal parts would be susceptible to corro-
sion under such circumstances;
- in rooms where the temperature could drop
below freezing. Do not expose the appliance
any weather.
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.).
Adjusting the feet
CAUTION:
The feet must never be removed. Do not restrict the
floor clearance through carpets, strips of wood or
similar.
Danger of heat accumulation!
 Turn the feet to the right to let down the appli-
ance; turn to the left to lift it up. The feet must
have solid ground contact.
 Check with a spirit level whether the appliance is
leveled horizontally. If the unit is not in balance,
the feet must be adjusted again.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an
electric
shock
!
 Do not use multiple sockets or extension cords.
 It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
 The accessibility of the power plug must always
be ensured in order to disconnect the device from
the power supply in case of an emergency.
 Make sure that the voltage supply matches the
specifications on the rating label (appliance back)
before connecting.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.