BOMBARDIER Outlander 400

Questions and Answers

B
Brandon SandovalAug 16, 2025
What to do if my BOMBARDIER Outlander 400 Offroad Vehicle engine turns over but fails to start?
- D
  Deborah FosterAug 16, 2025
  If your BOMBARDIER Offroad Vehicle engine turns over but doesn't start, check that the engine stop switch is in the ON position. Ensure the fuel mixture is rich enough, verifying the fuel tank level and choke usage. If the engine is flooded (spark plug wet), refer to SPECIAL PROCEDURES. If there's no fuel (spark plug dry), check the fuel tank level and fuel valve position (ON or RES). A fuel pump or carburetor issue might exist, so contact an authorized Bombardier ATV dealer if needed. Finally, check the spark plug for spark. If no pulsating resistance is felt when using the rewind starter, it suggests a major loss of compression, in that case contact an authorized Bombardier ATV dealer.
N
Natasha CurryAug 18, 2025
Why my BOMBARDIER Outlander 400 cannot reach full speed?
- P
  Priscilla FoxAug 18, 2025
  If your BOMBARDIER Offroad Vehicle cannot reach full speed, first check the parking brake to ensure the brake lever lock is completely removed. Also, inspect the air filter and clean it if necessary, check for deposits in the air box drain, and verify the position of the air intake tube. For engine-related issues, see ENGINE LACKS ACCELERATION OR POWER. If the CVT is dirty or worn out, contact an authorized Bombardier ATV dealer.
D
Donald HendersonAug 22, 2025
How to fix a hard to move transmission lever on a BOMBARDIER Outlander 400 Offroad Vehicle?
- C
  Chad BrewerAug 22, 2025
  If the transmission lever on your BOMBARDIER Offroad Vehicle is hard to move, try rocking the vehicle back and forth to move the gears in the transmission and allow the lever to be set. If the engine idle speed is too high, adjust it according to the SPECIFICATIONS. If the CVT is dirty or worn-out, contact an authorized Bombardier ATV dealer.
D
Deanna HollandAug 25, 2025
What to do if my BOMBARDIER Outlander 400 engine does not turn?
- C
  clopezAug 26, 2025
  If your Bombardier Offroad Vehicle's engine won't turn, there are several potential causes. First, ensure the ignition switch is in the ON position. Next, confirm the transmission is set to PARK or NEUTRAL, or press the brake lever. Also, check the main fuse and charging system fuse for any issues. Inspect the battery connections and terminals for looseness or corrosion. It may also be necessary to have the battery checked.
J
Jared LunaAug 27, 2025
Why my Bombardier Offroad Vehicle engine turns over but fails to start?
- C
  Christine RossAug 28, 2025
  If your Bombardier Offroad Vehicle engine turns over but doesn't start, the engine stop switch may be OFF, so ensure it's in the ON position. Also, the fuel mixture might not be rich enough; check the fuel tank level and the starting procedure, especially the choke. There might be no fuel reaching the engine; verify the fuel tank level and that the fuel valve is ON (try RES). Check the main fuse. Furthermore, it is important to verify the spark plugs/ignition: remove spark plugs then reconnect to ignition coil. Also, make sure that ignition switch and/or engine stop switch is/are at the ON position. If the engine has no pulsating resistance, it suggests a major loss of compression.
M
Michelle AustinAug 31, 2025
How to fix engine misfire in my BOMBARDIER Outlander 400 Offroad Vehicle?
- C
  Cindy RobertsAug 31, 2025
  To address engine misfire in your Bombardier Offroad Vehicle, start by inspecting the spark plug for fouling, damage, or wear; clean or replace as needed, verifying the heat range. Additionally, check for water in the fuel system; if present, drain the system and refill with fresh fuel.
K
Kimberly WatsonSep 2, 2025
What to do if the transmission lever is hard to move on my BOMBARDIER Outlander 400?
- E
  Erik MclaughlinSep 2, 2025
  If the transmission lever on your Bombardier Offroad Vehicle is difficult to move, it could be due to the transmission gears being in a bind. Try rocking the vehicle back and forth to realign the gears. Another cause may be that the engine idle speed is set too high, you should adjust the idle speed.
P
Pam HendricksSep 6, 2025
How to fix a BOMBARDIER Offroad Vehicle when the engine does not turn?
- B
  Brooke MorrisSep 6, 2025
  If the engine of your BOMBARDIER Offroad Vehicle does not turn, first, ensure the ignition switch is in the ON position. Next, check that the transmission is set to PARK or NEUTRAL, or press the brake lever. Also, examine the main fuse for any burning. Finally, inspect the battery for weakness or loose connections, checking the charging system fuse and terminal conditions. If the issue persists, have the battery checked by an authorized Bombardier ATV dealer.
S
Sierra BrownSep 9, 2025
Why does my BOMBARDIER Outlander 400 Offroad Vehicle engine lack acceleration or power?
- C
  Caitlin HuangSep 9, 2025
  If your BOMBARDIER Offroad Vehicle engine lacks acceleration or power, start by checking the air filter and clean it if necessary. Also, check for deposits in the air box drain and verify the position of the air intake tube. For spark plug and fuel issues, refer to ENGINE TURNS OVER BUT FAILS TO START. For carburetor adjustments, overheating issues, or a dirty/worn-out CVT, contact an authorized Bombardier ATV dealer.
J
Jon TurnerSep 12, 2025
What to do if the RPM increases but the BOMBARDIER Offroad Vehicle does not move?
- H
  Heather FordSep 12, 2025
  If the RPM increases but your BOMBARDIER Offroad Vehicle does not move, ensure that the transmission is not in PARK or NEUTRAL. Select the R, HI, or LO position. If the issue persists, it may be due to a dirty or worn-out CVT or water in the CVT housing; in either case, contact an authorized Bombardier ATV dealer.