96
Display Selection Button
To change the display momentarily
press the button on the speedometer.
The display will indicate odometer/trip
meter/hourmeter, one after the other.
To reset the trip meter, push and HOLD
button until all numbers read zero. The
trip meter can be reset at any time,
even if the odometer or the hourmeter
is selected.
TYPICAL
The odometer can indicate in miles or
in kilometers depending which unit is
selected.
9) Rear Passenger Grab
Handles
Quest MAX and Traxter MAX Series
The grab handles are located on each
side of passenger seat.
1. Grab handles
2. Passenger seat
The grab handles must be used by the
passenger to hold on firmly during ve-
hicle operation.
10) Ignition Switch
Quest MAX and Traxter MAX Series
Located at bottom of cluster.
Key-operated, 3-position switch: OFF,
ON with lights and ON without lights.
QUEST MAX SERIES
1. Ignition switch
V04I07Y
V01A41Y
1 12
WARNING
Never hold on to the operator. Al-
ways hold the grab handles firmly.
V01A42Y
V04I0HY
1
vmo2004_011a.book Page 96 Thursday, May 15, 2003 1:46 PM
To Next Page
Loading...
Need help?
General
