Need help?Do you have a question about the BONAIRE Integra VSS50 and is the answer not in the manual?
General| Brand | BONAIRE |
|---|---|
| Model | Integra VSS50 |
| Category | Air Conditioner |
| Language | English |
Key information and copyright details for the manual.
Outlines the obligations and training requirements for dealers and installers.
Emphasizes the need for dealers to ensure staff are adequately trained for correct product specification.
Details compliance requirements with codes, standards, and legal obligations for installation.
Covers installer safety, access, and risk assessment during installation on roofs.
Checklist for installers before starting the installation process, including checks for damage and components.
Checklist for selecting the correct unit location, considering noise, air quality, and structural support.
Guidelines for installing the metal dropper duct, including sizes, height, and fixing methods.
Step-by-step instructions for fitting the Enviroseal duct shutter below the dropper duct.
Procedure for removing Louvre panels and the fan/venturi assembly for easier unit handling.
Recommendations for using insulated ductwork, bends, joins, and ensuring smooth airflow.
Guidance on setting water bleed rates and drain cycle times for optimal performance and longevity.
Instructions for fitting the float valve and connecting the water supply to the unit.
Step-by-step guide on how to assemble and install the float valve into the tank.
Requirements for licensed plumbers and water pressure specifications for connecting the supply.
Details on connecting the Bonaire Aquamiser, including fitting the drain and selecting connections.
Step-by-step instructions for attaching the Bonaire Aquamiser assembly to the tank.
Various options and guidelines for connecting the unit's discharge pipe to drainage systems.
A diagram illustrating the electrical connections for the Aquamiser and control box.
Procedure for filling the unit and setting the correct water level in the Aquamiser.
Instructions for adjusting the filter rate (outer knob) and bleed rate (inner knob).
Importance of correct water management for longevity and warranty; setting bleed rates.
Step-by-step guide to configure the timed draining cycle for the unit using the Navigator control.
Instructions to set the delay for draining water after the unit is turned off.
Guide on how to connect and mount the transceiver for wireless communication.
Process for pairing the wireless Navigator controller with the unit's transceiver.
Overview of the system's capability to support multiple controllers and available configurations.
Explains how to join additional controllers to a master controller in a multi-controller setup.
Procedure for putting controllers into a 'JOin' mode to integrate them into the Navigator system.
Steps to enter the installer setup mode on the Navigator Controller to configure parameters.
A detailed table outlining parameters, their definitions, default values, and options for controller setup.
Guide to accessing the installer setup menu for the Evaporative Cooler controller.
Table of specific installer parameters for Evaporative Air Conditioners (EACs) with warnings about adjustments.
How to assign controllers to zones and how state changes reflect across all controllers.
Setting up two wired Navigators to ensure only one measures the common zone temperature.
Pairing and joining two remote Navigators for shared zone temperature measurement.
Setup process for multiple wired or wireless controllers in shared zones, ensuring temperature measurement is configured correctly.
Checks and procedures for ensuring the fan operates correctly and air is distributed evenly.
Refers to separate control installation and commissioning instructions.
Instructions on how to instruct the customer on product use, maintenance, and handover procedures.
A comprehensive checklist to verify all installation steps are completed before customer handover.
Phone numbers and emails for service inquiries and warranty claims across different states.
To Next Page
