Need help?Do you have a question about the BONAIRE VSS50 and is the answer not in the manual?
General| Brand | BONAIRE |
|---|---|
| Model | VSS50 |
| Category | Air Conditioner |
| Language | English |
Copyright, reproduction rights, and product development policy.
Obligations for trained staff, sub-contractors, and compliance with regulations.
Compliance with codes, standards, and legal requirements for installation.
Ensuring safe installation environment, access for service, and safety anchorages.
Checks for damaged products, system components, correct unit, and design conformity.
Guidelines for unit placement regarding noise, air sources, structural support, and service access.
Instructions for installing the metal dropper duct, including size, height, and fixing requirements.
Steps for installing the Enviroseal duct shutter, ensuring correct placement and operation.
Procedures for removing louvre panels and the fan/venturi assembly for easier handling.
Guidelines for storing fan assembly, lifting unit, locating on dropper duct, and securing it.
Reconnecting fan loom, water solenoid, communication cables, and feeding service lead.
Requirements for insulated ductwork, bends, joins, and sealing for optimal airflow.
Visual guide for insulated ductwork, sealing joints, and smooth radius bends for airflow.
Importance of correct water management for operation, longevity, and warranty.
Procedures for fitting the float valve, including washer placement and nut tightening.
Requirements for water supply pipework, plumber installation, and pressure limits.
Details on flexible connections, freeze protection, pipe material, and isolating valves.
Steps for fitting the overflow assembly, including washer placement and securing the nut.
Detailed steps for installing the 50mm BSP overflow fitting.
Installation steps for the Enviroflow system, including dump valve and cable connections.
Requirements for discharge pipe diameter and managing discharge water per regulations.
Options for discharging drain water into roof gutters, downpipes, or stormwater systems.
Sanitary drainage options via tundish to floor waste gully or direct to sanitary drain.
Options for discharging drain water to an absorption pit or a water spreader.
Important notes for electrical connections, emphasizing licensed electricians and dedicated circuits.
Instructions for licensed electricians to install dedicated circuits and GPOs.
Details on drilling holes, fitting grommets, connecting cables, and securing electrical leads.
Schematic illustrating electrical connections for the unit's components.
Instructions for filling the unit and checking water levels relative to the overflow pipe.
Procedure for filling the unit and verifying the correct water level.
Adjusting filter rate and bleed-off rate using control knobs for water flow.
How to adjust the outer knob to control water flow to the distributor.
Setting the bleed rate using the inner knob to prevent mineral deposits.
Adjusting bleed rate for water hardness and recommendations for plumbing bleed off.
Setting dump valve timed periods based on water hardness and control options.
Checking fan running, clearance, and even air distribution through ductwork.
Reference to separate control installation and commissioning instructions.
Instructing the customer on product operation, controls, and maintenance.
A checklist for verifying unit installation, connections, and functionality.
Checks for Enviroseal operation, roof penetrations, ductwork airtightness, and air distribution.
Ensuring the site is clean from rubbish after installation.
Key points to explain to the customer regarding operation and maintenance.
Importance of periodical service by qualified technicians for efficiency and warranty.
To Next Page
