CA
Thin CA
Trial fit the vertical stabilizer in place .
Check the alignment of the vertical stabilizer.
When you are satisfied with the alignment, use a pencil
to trace around the left and right of the vertical stabilizer
where it meets the fuselage.
With the perpendicular, check the alignment of the vertical
stabilizer and the horizontal stabilizer.
When you are satisfied with the alignment, secure the vertical
stabilizer in place using thin CA glue.
Remove the vertical stabilizer from the fuselage.
Using a sharp hobby knife, carefully cut away the
covering below the lines which were drawn in the
previous steep. Do not cut into the woods as this
will affect the structural integrity of the stabilizer.
Again, insert the vertical stabilizer into the fuselage.
CA
! Securely glue together. If coming off during fly,
you lose control of your air plane.
90
90
CA
Cut away only
the covering
Note: the rectangular hole for the control horn
installation is pre-cut at factory.
Plastic control horn
.....................1
8- Vertical Stabilizer
Cut away only the
covering both sides.
To Next Page
Loading...