9
OPERATION
1. Make sure your heater has been assembled properly.
2. Push in the shut-o gate.
3. Fill hopper with pellets. The pellets will not fall into the repot at this point since the shut-o
gate is closed.
4. Open the door, pull out the shut-o gate completely. This will allow pellets to fall into repot.
5. Squirt a small amount of lighter uid or gel onto the pellets and ignite with a butane lighter or
match and close the door.
6. Keep the door closed when using the heater. If the door is open, the heater will lose its draft
and the pellets will not burn properly.
7. During the initial burn, the high temperature powder coating goes through a curing process.
While curing, it will give o smoke during the rst 15 minutes of use. This is normal and
temporary.
8. After several hours of use you may have excess pellets piled up at the bottom of the repot,
you will need to open the door and use the re poker to stir the pellets. This only needs to be
done after several hours of use to help ensure maximum heat output.
To Next Page
Loading...