Installation manual BMG for Creality CR-10 V1.0 1
Table of Contents
Acknowledgements 1
Introduction 1
Compatibility 2
What’s in the box? 2
Mechanical Installation 2
What you need 2
Software Configuration 9
Using original firmware 9
Using custom firmware 10
General usage advice 10
Acknowledgements
Special thanks to Don Stauffner for the help with the design of the housing for the
filament sensor.
Introduction
The Bondtech BMG 1.75 mm extruder is the simplest way to increase the
performance and reliability of your Creality CR-10 printer in a matter of minutes.
This new revolution in design utilizes the proven Bondtech Dual Drive Technology
with precision CNC-manufactured parts. This gives the market’s best feeder
performance and reliability.
The Upgrade allows you to prototype even faster and print with peace of mind.
To Next Page
Loading...