Installation manual BMG for Creality CR-10 V1.0 2
Compatibility
The upgrade is compatible with the following machines:
- Creality CR-10
- Creality CR-10S
What’s in the box?
1x Bondtech BMG Righthand extruder with a filament guide.
1x Motor gear
4x M3 Nuts (installed into bracket if purchased)
4x M3x8 bolts
1x Mounting bracket
As we share the files of the mount you can also buy the kit without the mount and
print the part yourself.
Mechanical Installation
What you need
To install the upgrade you are going to need
- M1.5- Hex Wrench
- M2.0- Hex Wrench
- M2.5- Hex Wrench
- Hobby knife with sharp tip or similar.
This guide shows the installation on an Creality CR-10S printer
Start by unloading the material from your printer. After the filament has been
removed, turn off the heater, wait for it to cool down, then turn of the printer.
To Next Page
Loading...