9
en
The BONECO P500 can easily be adapted to suit your
needs. Whenever you switch off the unit, all settings are
saved until the next use. However, the settings are reset
whenever the unit is disconnected from the power supply.
“AUTO” COMFORT MODE
In the mode, the BONECO P500 is fully automatic
and controls the fan levels, achieving an optimum effect.
The fan runs at level 1 when air quality becomes satis-
factory. After 15 minutes at level 1, the fan shuts off until
the air quality diminishes again.
“SLEEP” COMFORT MODE
In comfort mode, the fan operates at the lowest
level to keep the noise level as low as possible. This set-
ting is suitable for use in a bedroom, nursery or baby's
room.
COMFORT MODE SWITCH
1. On the keypad or the remote control, push the
button to switch between and comfort
modes.
BASIC FUNCTIONS
AIR QUALITY INDICATOR
The air quality is shown on the display by 8 segments. The
better the air quality, the more segments are displayed
in white:
MANUALLY CONTROLLING THE FAN LEVEL
The fan level of the BONECO P500 can be controlled
manually, such as if you want the air to be thoroughly
purified in the shortest possible time.
1. Push the button repeatedly until the desired fan
setting is achieved.
2. On the keypad or the remote control, push the
button to switch back to the or comfort
mode.
POWER LEVEL
The power level (P) can only be selected manually using
the button. The fan is now working at its maximum
output.
USING FRAGRANCES
The fragrance container for adding fragrances is on the
backside of the BONECO P500.
1. Briefly push on the fragrance container to unlock it and
then remove the compartment.
2. Insert the fragrance into the fragrance container.
3. Push the fragrance container into the air purifier until
it clicks into place.
To Next Page
Loading...
Need help?
General
