Description of the appliance
Unpacking
• Carefully remove the humidifier from the box.
• Important: the vapour outlet is stowed in a red bag
in the cardboard insert. Make sure that you take the
vapour outlet from the packaging.
• Remove the plastic bag from the humidifier.
Putting into operation
Finding the ideal location for your humidifier
• Do not place the humidifier directly next to a heating
element or on a floor with floor heating. The moisture
of the mist can damage the floor surface (6) (see
Safety Instructions).
• The vapour outlet must not be pointed directly at plants
or other objects. Keep distance of at least 20inch) (11).
• The Ultrasonic should be placed in a higher position
(on a table, commode etc.)
• Soak the demineralisation cartridge in the watertank
approx. 24 hours before using it. The resin has to
absorb water to reach high performance.
• On average the demineralisation cartridge should be
replaced every 2 – 3 months depending on your water
hardness. Some areas may need to replace the cart-
ridge sooner some may last longer. See «Replacement
of the demineralisation cartridge».
• Read the instructions under «Filling the Tank» for
putting water in the humidifier.
• Place the water tank on the base and insert the vapour
outlet.
• Insert the plug into the socket and switch on the
appliance using the on/off switch (16).
• About 10 to 15 minutes after having been switched on
the device will reach is full power.
• Make sure that the cable is not pinched anywhere
(8 – 9). Do not operate the humidifier if the cable is
damaged (2).
Water-level sensor
Reservoir
Air inlet
Membrane
Vapour outlet (rotating)
Evaporation chamber
Water tank
Water tank cap
Demineralisation cartridge
Brush
Power cord
Control panel
Main body
• Observe the information given on the rating plate about
the mains supply.
• Use the original packaging for storing the appliance if
you do not use the humidifier all year round.
en
To Next Page
Loading...
