EasyManua.ls Logo

Bonga TRIFLEXX - Build Plan

Default Icon
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
BUILD PLAN
8,5 M X 12,5 M
SAFARI
The safari design is characterised by relatively few poles and more clamps. On the one hand
there is a clamp at the top of each side pole*. There is also a clamp mounted on the canvas on
the reverse sides of the pole. The tension straps/ropes of all three clamps are pulled to the same
anchoring point.
Each of the short sides has 1 side pole. Each of the long sides has 2 side poles.
Various designs are possible with the Bonga stretch tents, but we will explain two here: the safari
design and the freeform design.
* If the poles are placed outside the canvas, the instructions must be followed for the use of an eyebolt with threaded rod in
step 1.2.2 (use of wooden poles) and step 1.1.1 (use of aluminium poles). ** Recommended length = pole length
8,5 m
12,5 m
Peg
Tension strap/
rope**
Reinforced zone
Corner clamp
with pole
Aluminium pole: 220 cm (2 x 110 cm) - Wooden pole: 240 cm
Side clamp
without pole
Side clamp
with pole
Middle pole
Aluminium pole: 270 cm (2 x 110 cm + 1 x 50 cm) - Wooden pole: 280 cm
Aluminium pole: 380 cm (3 x 110 cm + 1 x 50 cm) - Wooden pole: 360 cm
- - -
Weld