4
Overview
1 Standby / Emergency stop button 8 Casters
2 Forward in feed 9 Removal tray (Handle)
3 In feed for CDs/DVDs 10 Overheating light
4 In feed for paper and credit cards 11 Overflow light
5 Main switch 12 Reverse in feed
6 Collection unit for CDs/DVDs 13 Cooling vent
7 Collection unit for paper and credit cards 14 Mains power supply
Installation and operation
Place the equipment on a flat and even surface.
Make sure that the equipment is placed away from any radiators or hot areas.
Do not cover the cooling vent at the rear of the equipment.
Avoid the use of extension cables and multiple power sockets if possible, and connect
the equipment directly to a wall socket (as specifie
d in the section on technical information).
Please keep the equipment at a distance of at least 4 inch away from the wall in order to
ensure the cooling vent has an adequate supply of air.
Operation:
Switch on the power button at the rear of the machine ("ON"). The symbol for standby mode which is
displayed as (“Standby”) will light up and the machine will go into standby mode.
The equipment is now ready to use. Should the symbol not light up, then please refer to the s
ection
"General Troubleshooting" on page 8 of this manual.