EasyManua.ls Logo

BonsenKitchen VS3750 - Page 13

BonsenKitchen VS3750
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 13 -
1) Cut the desired length for your bag from the roll
using a pair of scissors. Cut as straight as
2) Open the appliance lid
① by pressing the lid
release ⑧and opening the lid ① upwards.
3) Lay the open end of the bag as far into the
appliance so that the opening of the bag is located
centrally under the lower sealing ring
⑤. The bag
should be inserted no further than the rear limiters
⑥
and must lie between the front limiters ⑦. If the
bag lies over one or both of the two limiters ⑦, then
the bag cannot be correctly welded.
NOTE
►The bag opening must lie flat on the welding wire
VAC Seal
VAC Seal
possible.