- 14 -
④.Otherwise the welding does not work properly.
4)
Close the appliance lid ①. The press seal ⑩
presses the bag onto the welding wire ④, to create
a smooth seam. Ensure that both corners of the
appliance lid ① click closed. If necessary, press
them down once again on the markings and
so that the appliance lid ① clicks into place and
locks tightly.
5) Press the Food button Mode Selection. If the choice
is dry, the dry indicator will light on . If the moist is
chosen, The Moist indicator lights up.
NOTE
►You can halt the sealing process at any time by
pressing .The seal lamp goes out.
CAUTION – PROPERTY DAMAGE!
If the seal lamp does not go out after a maximum
of 10 seconds, there is a fault with the appliance.
► Remove the plug from the mains power socket
immediately. Do not attempt to repair the appliance
yourself. Contact the Customer Service department.
To Next Page
Loading...
