How to fix a blank display on Bontrager TRIP 1?
If the display on your Bontrager Bicycle Accessories is blank, it's likely due to a battery issue. The battery may be low, not installed, or installed incorrectly. Ensure the battery is installed correctly or replace it if needed.
Why is the speed incorrect on my Bontrager TRIP 1 Bicycle Accessories?
If the speed displayed on your Bontrager Bicycle Accessories is incorrect, there are a couple of potential causes: * The wheel size setting might be wrong. In this case, you should reset the wheel size. * The magnet might be misaligned or too far from the sensor. Try to readjust the magnet and sensor alignment.
What to do if the current speed is missing on my Bontrager Bicycle Accessories?
If you find that the current speed isn't being displayed on your Bontrager Bicycle Accessories, there are a couple of things to check: 1. Make sure the magnet is properly aligned with the sensor and is not too far away. If it isn't, readjust the magnet and sensor placement. 2. If you're using a Trip 4W, the wireless sensor battery might be low. Try replacing the battery in the sensor.
Why is the data erratic on my Bontrager TRIP 1?
If the data on your Bontrager Bicycle Accessories display is acting erratically, here are a couple of things you can check: * First, the magnet may be misaligned or too far from the sensor. Try to readjust the magnet and sensor placement. * Also, the battery might be low, not installed, or installed incorrectly. Make sure the battery is correctly installed, and replace it if necessary.
General| Display Type | LCD |
|---|---|
| Battery Life | Up to 1 year |
| Speed Measurement | Yes |
| Distance Measurement | Yes |
| Time Measurement | Yes |
| Water Resistance | Yes |
| Battery | CR2032 |
| Odometer | Yes |
| Clock | Yes |
| Wireless | No |
| Waterproof | Yes |
| Mount Type | Handlebar mount |
| Compatibility | Universal |
| Functions | Speed, distance, time, clock |
| Type | Wired cycling computer |
Program wheel size, units (MPH/KMH), and time using the buttons.
Configure the clock display to 12 or 24-hour format and set the correct time.
Instructions for mounting the wired Trip 1 computer on handlebars or stem.
Guide for attaching the wire, wheel sensor, and magnet for the wired system.
Instructions for mounting the wireless Trip 4W computer on handlebars or stem.
Guide for installing the wireless wheel sensor and magnet for the Trip 4W system.
To Next Page