What to do if data is erratic on Bontrager Bicycle Accessories?
If the data displayed on your Bontrager Bicycle Accessories is showing erratic readings, it might be due to a misaligned magnet or one that's too far from the sensor. Try readjusting the magnet and sensor placement to ensure they are properly aligned. Alternatively, the battery could be low, not installed, or installed incorrectly. In this case, replace the battery.
Why is current speed missing on my Bontrager TRIP 2?
If the current speed is not displaying on your Bontrager Bicycle Accessories, first check the magnet and sensor alignment. If the magnet is misaligned or too far from the sensor, readjust their placement. Also, if you are using Trip 5W, the wireless sensor battery might be low, so try replacing the battery in the sensor.
How to fix a blank display on Bontrager TRIP 2 Bicycle Accessories?
If your Bontrager Bicycle Accessories display is completely blank, the most likely cause is a problem with the battery. The battery may be low, not installed correctly, or not installed at all. Try reinstalling a new battery to resolve this issue.
Why is the speed incorrect on my Bontrager TRIP 2 Bicycle Accessories?
If the speed displayed on your Bontrager Bicycle Accessories is incorrect, there are a couple of potential reasons. First, the wheel size setting might be incorrect; try resetting the wheel size. Second, the magnet might be misaligned or too far away from the sensor; in this case, readjust the magnet and sensor placement.
What to do if cadence is missing on Bontrager TRIP 2 (Trip 3 only)?
If the cadence is missing on your Bontrager Bicycle Accessories (Trip 3 only), the issue is likely due to the magnet being misaligned or too far away from the sensor. Try readjusting the magnet and sensor placement to ensure they are properly aligned.
Guide for setting wheel size, units (MPH/KMH), and temperature (°F/°C) upon first use.
Procedure to reset trip distance, average speed, max speed, and ride time to zero.
Method for accurately measuring and setting a custom wheel circumference (roll-out) for precise readings.
Instructions for programming a second wheel size, with icons for Wheel 1 and Wheel 2.
Procedure for replacing the device battery, noting the type and steps for removal and insertion.
Instructions to perform a device reset by holding the reset button for two seconds.
General| Wireless | Yes |
|---|---|
| Display | LCD |
| Functions | Current speed, Average speed, Maximum speed, Trip distance, Odometer, Clock |
| Mounting | Handlebar |
| Battery | CR2032 |
| Water Resistance | Yes |
| Current Speed | Yes |
| Average Speed | Yes |
| Maximum Speed | Yes |
| Trip Distance | Yes |
| Odometer | Yes |
| Clock | Yes |
| Auto Start/Stop | Yes |
| Wired | No |
| Type | Bike Computer |
To Next Page