Contents
Introduction
The BAR3 is an ice bath cooler designed to provide chilled product in a dispense application. The
system uses a bath water recirculation system and python to generate and maintain optimum drink
temperature at the point of dispense.
The BAR3 cooler is designed for effective performance and improved energy efficiency. It is ideal for a
range of applications, its compact size ideally suited to under counter installations.
Safety
The BAR3 units use different refrigerants dependant on the model selected. BAR300 models use R134a
refrigerant, whereas BAR3H Hydrocarbon units use R290 (Care 40, Propane). Below are some safety
points which the end user must adopt to mitigate the risk of unsafe conditions arising.
Service must only be carried out by a suitably qualified refrigeration engineer.
The unit should be isolated from the electricity supply before removal of the covers.
Do not damage the refrigeration circuit.
Ventilation openings must be clear of obstructions.
There must be a gap of at least 100mm between the appliance and a wall or other restriction.
Where electrical components are replaced, the new component must be of the same type.
Operate unit within (ambient) operating temperatures; 10°C to 32°C.
To Next Page
Loading...
