Connect the dispense python to the ‘Recirculation’ Flow and Return.
Connect the product to the stainless steel product coil.
BAR3H - For details on how to install Tube in Tube/Scope dispense, please contact Brandels at
http://www.brandels.co.uk/. Alternatively, please phone on 01253 501800 to speak to one of our
advisors.
Connect the unit to mains power.
Turn on the mains voltage supply. After a short delay the compressor fans will activate. The unit
will now begin to reduce the bath water temperature.
Continue to monitor the bath level as the python fills with water. Top up if necessary.
Once the water is at the correct temperature an ice bank will begin to form. As the ice begins to
form, a small amount of water will be displaced.
Once a full ice bank is produced, the fans and compressor will switch off and the machine is ready
for use.
To Next Page
Loading...
