59
Automatic stop at the end of the cooking time:
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press the key [ 00 ].
Egg timer function:
Example for 29 minutes:
Action
Control panel Display
Activate the hob press display [ ] zone control lights are on
Select« Timer » press display [ CL ] [ 00 ]
Set the units slide on the “SLIDER“ to [ 9 ] [ 0 fixed ] [ 9 blinking ]
Valid the units press display [ 09 ] [ 0 blinking ] [ 9 fixed ]
Set the tens slide on the “SLIDER“ to [ 2 ] [ 2 blinking ] [ 9 fixed ]
Valid the tens press display [ 29 ] [ 29 ]
After a few seconds the control light stops with blinking.
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press the display [ 00 ]. The hob switches off.
Automatic cooking
All the cooking zones are equipped with an automatic “go and stop” cooking device. The cooking
zone starts at full power during a certain time, then reduces automatically its power on the pre-
selected level.
Start-up:
Action Control panel Display
Zone selection press display [ 0 ] selected [ 0 ] and control light on
Full power setting slide on the “SLIDER“ to [ 9 ] pass from [ 0 ] to [ 9 ]
Automatic cooking re-press on display “SLIDER“ [ 9 ] [ 9 ] is blinking with [ A ]
Power level selection slide on the “SLIDER“ to [ 7 ] [ 9 ] pass to [ 8 ] [ 7 ]
(for example “ 7 “) [ 7 ] is blinking with [ A ]
Switching off the automatic cooking:
Action Control panel Display
Zone selection press [ 7 ] from the zone [ 7 ] blinking with [ A ]
Power level selection slide on the “SLIDER“ [ 1 ] to [ 9 ]
Pause function
This function brakes all the hob’s cooking activity and allows restarting with the same settings.
Startup/stop the pause function :
Action Control panel Display
Engage pause Simultaneously press [ II ] on display
the 2 rear cooking zones
Stop the pause Simultaneously press [ II ] blinking
the 2 rear cooking zones,
re-press the blinking display Previous setting
on display
To Next Page
Loading...
