- 9 -
3.2.2. When the treadmill is in FAT mode, the chosen sequence is “Sex”“Age”“Height”
“Weight”.
3.3. START button: Press this button to start the treadmill, the treadmill will run at the lowest speed
or at the speed of the default program after 3 seconds of time count down.
3.4. PAUSE/STOP button: When the treadmill is running, press this button once to slow down the
treadmill and stop into the PAUSE state. All data will remain. In this PAUSE state, if you press this
button twice, the treadmill will stop completely and all the data will reset. But in this PAUSE state, if
you press the START button, the treadmill will start running and continue the data of the PAUSE
state.
3.5. SPEED −/+: Adjust the speed. Press the button to adjust the speed when running, or adjust the
data when stop.
3.6. SPEED (1, 3, 5, 7): Adjust the speed quickly.
3.7. LEFT HANDRAIL button: Start/Stop adjustment button.
RIGHT HANDRAIL button: Speed adjustment button.
Notice: When any button is pressed, it will be accompanied by a prompt tone. When the button is
adjusted for parameter overrun, it will be accompanied by a long tone prompt. There is no beep
when the button is pressed invalid.
4. MAIN FUNCTION
Open the power switch, the screen window will light up, the treadmill will enter into the standby
state.
4.1. START-UP QUICKLY (MANUAL):
Put safety key, press the “START” button, the treadmill will run at the lowest speed in 3 seconds,
press the SPEED −/+ to adjust the speed. Press the “STOP” button or take out the safety key directly
to stop the treadmill.
4.2. COUNT DOWN MODE:
Press the “MODE” button, you can choose time countdown mode, distance count down mode,
calories countdown mode, and the screen window will show the default data and glitter. At the
same time, press the SPEED −/+ to set the data. Press the “START” button, the treadmill will run at
the lowest speed, you can press the SPEED −/+ to change the speed. When it counts down to 0, the
treadmill will stop smoothly. Certainly, you can press the “STOP” button or take out the safety key
from the computer to stop the treadmill.
4.3. INNER INSTALL PROGRAM:
Press the “PROG” button to choose the inner install program from “P1-P15”. When setting the
program, the time window will show default data and glitter, press the SPEED −/+ button to set the
running time. Each program has been divided into 20 sections, each exercise time=the setting
time/20. Press “START”, the treadmill will run at the first section speed. When the section is over, it
To Next Page
Loading...