TREADMILL MAINTENANCE
Warning: Always unplug the treadmill from the electrical outlet before cleaning or servicing
the treadmill.
Clean:
General cleaning the treadmill will greatly prolong the treadmill.
Keep the treadmill clean regularly. Be sure to clean the exposed part of the deck on either
side of the walking belt and also the side rails. This will reduce the build-up of foreign mate-
rial under the walking belt by wearing clean running shoes.
Warning:
Always unplug the treadmill from the electrical outlet before removing the motor
cover. At least once a year remove the motor cover and vacuum under the motor cover.
RUNNING BELT AND DECK LUBRICATION
This treadmill is equipped with a pre-lubricated, low-maintenance deck system. The belt
and deck friction may play a major role in the function and life of your treadmill, thus requir-
ing periodic lubrication. We recommend a periodic inspection of the deck. You need contact
our service center if you find damage to the deck.
We recommend that lubricating the deck according to the following timetable:
→ Light user (less than 3 hours/week): annually
→ Medium user (3-5 hours/week): every six months
→ Heavy user (more than 5 hours/week): every three months
We recommend that you buy the lubrication from our distributor or directly from our com-
pany.
Attention: Any repair needs a professional technician.
1. We suggest that you should turn off the power for 10 minutes after keeping running for 2
hours so that it’s good for maintaining the treadmill.
2. For avoiding the slipping during running, the belt is not too loose, for avoiding more
abrasion between the roller and belt and maintaining the treadmill good running, the belt
is not too tight. You can adjust the distance between plates and belt, the belt is away from
the plates about 50-75 mm on both sides, of the best not too tight or loose.
- 13 -
To Next Page
Loading...