BORK i 780 - Language Configu Ration

8 9
This device is intended for operation with
distilled or demineralized water.
If water runs out during ironing, then water
tank lights will be activated in 30 seconds–
2 minutes (depending on the set mode)
and NO WATER indicator will start flashing
onthedisplay. The steam supply will be
stopped.
Long-time operation of the device without
water in the steam supply mode may cause
damage to the pump. Do not allow the tank
tobe completely empty, replenish water
in≈it≈in≈a timely manner.
If the water tank is not filled, then the iron will
activate the dry ironing mode in 15 seconds.
PRIMARY CLEANING OF THE STEAM
GENERATION SYSTEM
• Fill the water tank
• Connect the device to mains.
• Use the temperature adjustment sensor
inorder to set the temperature mode LINEN.
• Press the steam shot button in order
toevaporate all water from the tank.
A smell or visible white deposits may come
outfrom holes in the soleplate of the iron.
Itwilldisappear in the course of operation.
Perform a primary cleaning of the steam system
again after a long period of inactivity of the
device.
• Remove and safely dispose all packaging
materials.
• Remove a protective cover from the soleplate
of an iron.
• Perform a primary cleaning of the steam
generation system.
RULES OF CONNECTION
TO A POWER OUTLET
• Do not touch a plug with wet hands.
• Connect the device to a grounded outlet only.
• When disconnecting the device from mains
dо not pull the cord, rather pulling the plug.
LANGUAGE CONFIGURATION
Select one of options for provision
ofinformation messages: Russian (default),
English or symbolic.
Hold the sensor
, adjusting a steam
generation level, and temperature mode
adjustment sensor
together for 8 seconds.
The message CLEANING will appear
onthescreen in 4 seconds. Continue
sensors holding up to flashing indication
ofthetemperature mode, provided
onthescreen at the moment oflanguage
configuration beginning (for example, WOOL).
FILLING OF THE WATER TANK
• Disconnect the device from mains.
• Set the device to the horizontal position.
• Open the tank cover.
• Place the orange nozzle on the spout
ofthewater tank.
• Place the orange nozzle into the opening
ofthe tank and fill the tank through it.
Pour water into the iron only using the supplied
water tank, directing a stream accurately into
the opening. Do not fill water above the MAX
mark. Avoid getting of water to the iron housing.
• Close the tank cover.