BORK X 780 - Corrective Measures

30 31
CORRECTIVE MEASURES
• In case of faults in the device’s functionality,
itisnecessary refer to the Troubleshooting section.
If it is not possible to fix the problem, immediately
stop using the device refer to the nearest BORK
service center for testing, replacement or repair.
• For safety reasons, all repair procedures and
maintenance of the device must be performed only
in authorized BORK service centers. Addresses
and telephone numbers of service centers can
befound on the site www.bork.ru or by calling
thephone number 8 800 700 88 99.
• If there is damage of any kind, stop using the
device and contact the nearest BORK service
center for testing, replacement or repair. Do not
remove the product rating label, it is necessary
foraccurate identification of the device in the event
ofa malfunction.
• The device must be disposed in accordance with
law requirements of the country, in which it is used.
• It is prohibited to immerse the device, its cord
or plug into water or other liquid. It is prohibited
to allow formation of condensation water on
the device, it is prohibited to operate the device
inareas with high humidity.
• In the case of transportation or storage
ofthedevice at a negative temperature and after
itstransfer to warm temperatures, it is necessary
tokeep it turned off for at least 4 hours before use.
• Do not operate the device without the internal
baking form installed.
• Carefully handle the baking forms and blades
intended for kneading and mixing. Avoid damage
to non-stick coatings. Forms for baking and
blades have natural wear and tear, their service
life depends on the application frequency and
correctness of use.
• It is prohibited to spray or apply any chemicals
tothe device.