The material in the instruction guide & website is for information
purposes only. The SD1 watch described is subject to change without
prior notice , due to the manufacturer’s continuous de velopment
program. The SD1 watch & instruction guide are intended to support
a sensible approach to health & fitness. They are not intended to
replace professional medical ad vice related to diet , exercise or
weight loss. Physical enterprises shall not be liable for any damages ,
direct or incidental , conse quential or special , arising out of , or
related to ,the use of SD1 watch & accompan ying documents. If you
experience severe or prolonged discomfort or pain at any time , see
your doctor immediately. The information in the instruction guide is
intended to be used as a general guide only & may not be appropriate
to specific users. In particular : maximum heart rate. Consult a doctor
to determine your personal ma ximum heart rate. Borofone uses
comple x formulae that generally predict the hr based upon studies
of sub jects with healthy hearts. The percentage of maximum
calculations are not to be relied upon especiall y if you ha ve a history
of heart disease , stroke , high or low blood pressure , diabetes ,asthma
or other circulatory or respiratory conditions. Calorie target &
expenditure : reliance on inappropriate intake & expenditure targets
may result in excessive weight gain or loss , fainting , dietary
deficiencies or other adverse medical conse quences. Consult a doctor
to determine what caloric intake & expenditure targets are appropriate
for you. The SD1 watch , while designed to pro vide an ekg-accurate
heart rate , is neither designed nor warranted for medical use &
should not be relied upon for medical purposes. Always consult a
doctor before beginning a new exercise regime or diet program of
any kind.
20. DISCLAIMER
18
3. ACTIVATING SD1
1) Remove your SD1 from the packaging and peel off the protective film
on the display.
2) Press and hold the
S TA RT button (the upper right button) to wake up
the watch. The display will be switched on.
4. QUICK START
To get started, your SD1 will ask you to set several parameters.
» Press
+ or – to increase and decrease the values
» Holding
+ or – will rapidly change the values
» Press
SET to confirm the value and move to the next parameter
For detailed information on setting up your SD1, please see Section 14.
Borofone Tip: Locking the heart rate sensor will prevent unwanted heart
rate readings while setting up the watch. See Section 8 for more
information.
Time
» Hour (12 hour format)
» Minute
» Second (whenever + or – is pressed the second will be reset to zero)
» Hour format (12 hour or 24 hour format)
Date
» Date format
(Month-Day or Day-Month)
» Year
» Month
» Day
After finishing the quick first time setup, the watch will go to Time mode.
Personal Info rmation
» Unit Format (KG/CM or LB/IN)
» Body Weight
» Height
» Gender (Female or Male)
» Birth Year
03
To Next Page
Loading...