6
Børresen loudspeaker models are protected during
transport by stable and secure packaging.
Due to their weight and dimensions, they are shipped
in a special, double layer box.
Please consult your Børresen dealer who in most
cases will unpack and set up your new product.
1. Carefully lay the transport box at on a plane oor
.
2. Remove the straps from the outer carton and pull
the lid to reveal the inner box.
3. Open the inner box. Do not use knife or sharp
instruments to break the tape.
4. Put on protective white gloves for further handling
of the loudspeaker.
5. Now, lift the box to an upright position.
6. Pull the loudspeaker and the protective foam out
of the box, sliding it on the bottom foam. Be carefull
not to tilt.
7. Remove the bottom foam by tilting the
loudspeaker and then the remaining foam to unpack
the loudspeaker completely.
7. Put the loudspeaker to the position you desire.
8. Please observe guidelines for positioning and
connecting your loudspeakers on page 7 and 8.
UNPACKING
To Next Page
Loading...