BORRESEN X3 - Connecting the Speakers; Connect Loudspeaker Cable; Amplifier Connection and Safety

X3 / USER GUIDE 7
With every connection system, ensure that the
contact is tight and has a proper contact area.
Connectors with gold plating will typically offer the
best results and remain corrosion-free.
Please ensure that the positive and negative cables
do not make contact with each other.
Check the connectors from time to time to make sure
that nothing has loosened.
1. Connect a two-pole (+/-) loudspeaker cable to the
binding posts, located at rear of the loudspeaker.
The high quality binding posts can accommodate
only 4-mm-plugs (“banana plugs”).
The pins can be put directly into the binding post
without any tightening necessary.
2. Connect the other cable ends to the loudspeaker
outputs of your switched off amplier.
CONNECTING THE SPEAKERS
Distorted output signals from too weak, defective or
overloaded ampliers may damage the loudspeakers.
Use high quality ampliers only and run loudspeakers
and ampliers within specied power ratings.
CAUTION
RS-232
TRIGGER
THROUGH
ON / OFF
PRE OUTLINE IN
12 34 5