Bort Alligator X - Usage and Cleaning Guide; Troubleshooting, Service, and Disposal

16
removing the seized rotor with a tool.
• Do not store any objects under the display to
ensure access to the button restart.
DO NOT
• Do not use hot water when grinding remains of
products (although hot water through the product
between grinding).
• Do not turn o the water or the product until the
grinding is completed, there is a noise of running
engine and running water.
• Do not grind large amounts of egg shells, brous
materials, for example corn husks, artichokes, etc.,
in order to avoid possible clogging of the pipe.
• Grind only food.
• Do not use this appliance to grind hard materials,
such as glass and metal.
• Never pour fat, oil or fat in shell, as this will lead to
clogging drainage and sewerage systems.
• Do not ll the disposer chamber with a large
amount of cleaning vegetables. Instead, turn on
the water rst and disposer and gradually lower it
cleaning.
CLEANING THE DISPOSER CHAMBER
Over time, fat / food particles can accumulate in
the grinding chamber and protective reector,
causing an unpleasant smell.
For cleaning grinding chamber and reector:
1. Turn o the EQUIPMENT and disconnect it from
the mains.
2. Through the drain hole using a sponge for
washing, clean the bottom surfaces protective
reector and inner upper edges of chopping
chamber.
3. Place the plug in the drain hole and ll the sink
with hot water halfway.
4. Mix 60 ml of baking soda with water. Turn the
product on and remove the plug from the sink.
washing of foreign particles.
ELIMINATION OF JUMMING DISPOSER
If during the operation of the disposer motor
stopped, possibly jammed moving parts.
To eliminate jamming:
1. Turn o the power of the disposer and shut o
the water.
2. Insert one end of the wrench into the center hole
on the bottom of the product for a self-contained
removal of stuck waste. Turn the wrench back and
forth until as long as he will not make one full turn.
Take out wrench.
3. Remove foreign objects from the help ticks with
long handles. Give to the engine of the product
cool for 3-5 minutes and press the red reset button
on the bottom of the disposer (If the engine
does not start, check the protective shield for the
presence of circuit breakers and burnt out fuses).
SERVICE
If you need to perform maintenance or repair the
product, contact an authorized service center or to
your dealer.
The warranty is canceled in the following cases:
- if the product was used with impairments
requirements of this manual
- in the presence of traces of the opening of the
body of the product for self-repair
For more details about the terms and conditions of
the warranty, see the warranty coupon
DISPOSAL
Discarded electric appliances are recyclable and
should not be discarded in the domestic waste!
Please actively support us in conserving resources
and protecting the environment by returning this
appliance to the collection centres (if available).
Made in China.